 |
| CUSTOM
PATTERN MAKER - Contents - pg i |
| (NOTE: The chart at the top of the page allows you to
jump from page to page.) |
TABLE OF CONTENTS
|
ABOUT CUSTOM PATTERN MAKER 1
|
|
CUSTOM PATTERN MAKER FAST START DIRECTIONS 3
|
|
CHAPTER I THINGS YOU NEED TO KNOW ABOUT WORKING WITH YOUR COMPUTER HARDWARE AND C.P.M. SOFTWARE 4 |
|
1. SYSTEM REQUIREMENTS. 4 |
|
1.1. CPU 4 |
|
1.2 . RAM 4 |
|
1.3. Video Card 4 |
|
1.4. Pointing Device 4 |
|
1.5. Plotter/Printer 4 |
|
2. INSTALLING CUSTOM PATTERN MAKER SOFTWARE 5 |
|
2.1. Copy the directory C.P.M. to the main trunk of your hard drive. 5 |
|
2.5. The first time you start up C.P.M. you will need to set the PREFERENCES. 6 |
|
2.5.2.1. Under DISPLAY: 6 |
|
2.5.2.2. Under GENERAL: 6 |
|
2.6. Under the OPTIONS menu is the UNITS command. 7 |
|
3. KEEPING DRAWINGS ON "FLOPPY" DISKS 8 |
|
CHAPTER II THE BASIC PATTERN BLOCKS 10 |
|
1. 2TORSO AND MALE 10 |
|
2. 1SEXBOD AND SLEEVE 10 |
|
3. DSLEEVE (DANCE SLEEVE) 11 |
|
4. PANT 11 |
|
5. SKIRT 11 |
|
CHAPTER III PROGRAM STRUCTURE THEORY 12 |
|
1. DESIGNED FOR COSTUME MAKERS 12 |
|
2. TASKS IT WILL PERFORM 12 |
|
5. PROGRAM RUNS WITH CURSOR DEVICE 13 |
|
6. VERTEX BASED DRAWING PROGRAM 13 |
|
CHAPTER IV. BASIC OPERATION INFORMATION 15 |
|
1. CONTROL DEVICES 15 |
|
3. COMPUTER COMMANDS 16 |
|
4. ENTERing COMMAND 16 |
|
5. POP-DOWN MENUS (VERY IMPORTANT - READ THIS) 17 |
|
|
